Filter
Top Products
masterpage:Left
filename[D:\WORKS\CD200\3067951121\3067951121MVCCD200UC\02GB-
MVCCD200UC\04bas.fm]
24
model name1[MVC-CD200/CD300]
[3-067-951-12(1)]
When you use the self-timer function, the subject is recorded about 10 seconds after
you press the shutter button.
Clear the menu (page 46), then press the control button
V
( ). The (self-timer)
indicator appears on the LCD screen, and about 10 seconds after you press the shutter
button, the subject is recorded. The self-timer lamp flashes and the beep sounds after
you press the shutter button until the shutter is released. To cancel the self-timer
recording, press the control button
V
()again.
The initial setting is AUTO (no indication). In this mode, the flash automatically pops
up and strobes if the camera senses that the surroundings become dark. To change the
flash mode, clear the menu (page 46), then press
v
( ) on the control button
repeatedly so that the flash mode indicator on the LCD screen changes.
Each time you press the button, the indicator changes as follows.
(No indication)
tt t
(No indication)
Forced flash : The flash strobes regardless of the surrounding brightness.
No flash : The flash does not strobe.
Popdowntheflashbyyourhandafterrecording.
You can change the amount of flash light with [ ±] (FLASH LEVEL) in the menu
settings (page 50).
To reduce the red-eye phenomenon
Set [RED EYE REDUCTION] to [ON] in the setup settings (page 84), the flash
strobes before recording to reduce the red-eye phenomenon. When [ON] is selected,
appears on the LCD screen.
Using the self-timer
Recording images with the flash
Self-timer lamp
Shutter button
V ( ) on the
control button
v ( ) on the
control button
01cov.book Page 24 Monday, August 20, 2001 3:27 PM