Filter
Top Products
49
ON
OFF
EXT
INT
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
If G.SYNC is set to ON, sync signals are added to all RGB signals.
If G.SYNC is set to OFF, sync signals are not added.
Sync signals are not added to the RGB signals.
Uses the external sync signal when input.
Resets to internal sync mode. HD/VD signals are output.
The input external sync signal is terminated at 75 on this camera.
The input external sync signal is terminated at 75 on the last
camera connected.
The field index is output.
Lets you control the on-screen menu.
Image output signals are scanned without using interlace. You can
continue to output image signals for field 1 only.
Image output signals are scanned using interlace.
Outputs a 1 vertical period amplitude for the image signal period.
Outputs before the image signal.
a)
The image signal is output at 3V from the external trigger.
The image signal is output immediately after the external trigger.
The parameters that can be set by the internal switches are as given below.
Switch
S1
S101
S102
S201-1
S201-2
S201-3
S201-4
R/B SYNC
HD/VD sync mode selection
75 termination switch
FLD OUT/DATA IN
Interlace / non-interlace
WEN pulse phase switch
Image output signal phase switch
Setting
OFF
EXT
ON
ON
OFF
ON
OFF
DefaultContentsFunction
a) Amplitude differs according to external trigger.
For details of switches S201-3 and S201-4, contact your Sony service representative.