Filter
Top Products
26
A-3. PROTOCOL
7
th
~8
th
dip switches are used for Protocol Setting.
Factory Default: Pelco-D or Pelco-P ( Auto detection)
DIP SW1- 7 DIP SW1- 8
OFF OFF Pelco-D or Pelco-P
A-4. BAUD RATE SETTING
The 9
th
Dip Switch is used for BAUD RATE setting.
DIP SW can be changeable to 2400bps, 9600bps.
Factory Default: 2400bps.
DIP SW1 9
th
BAUD RATE
OFF 2400
ON 9600
.
A-5. 485 TERMINATIONS
10
th
Dip Switch is used for 100Ω termination.
Set on 10
th
Dip Switch only for the last looped camera from the controller.
Even in case of only one camera, set on 10
th
Dip Switch of the cameras.
DIP SWITCH SETTING