Filter
Top Products
Operating your camera
C. System Integration
485(+)
•Please Observe Polarity!
1. When controledl by RS-485, Pelco-D protocol (Option), refer to the following.
A. DIP Switch Setting on the Camera
(Factory default : Camera Address = 01, Baud Rate = 2400bps)
485(-)
Receiver
•Up to 15 Cameras can be
controlled by 1 IR Remote
Controller & 1 Receiver. You
must set up each camera’s
address by DIP Switches for
proper addressing.
11 12
When you call Camera Address
01
->Push 0 Button
->Push 1 Button
->Push CAM Button
Power Connector
(DC12V in)
485(+),(-)
Baud Rate Setting
Buzzer On/Off
B. Receiver Setting to use with IR Remote Controller
(Factory default : Baud Rate = 2400bps, Chart is same as
above)
D. IR Remote Controller
-Can call and control each camera on the monitor by the following.
Multiflexer
CCD Camera
Monitor
SET / Menu buttonUP button
RIGHT button
DOWN
button
LEFT button
IR Remote
Controller
①②
RS485 Address Set
①
RS485 Baud rate Set
②