Filter
Top Products
www.svat.com
You should...
1. Check that the power cord(s) is properly connected.
2. Check that the monitor is turned ON.
3. Wrong AC/DC adapter used. Check that the adapter
labeled OUTPUT: 8V DC is connected to the camera, and
adapter labeled OUTPUT: 5V DC is connected to the monitor.
1. Check the channel switch settings on the camera (s) and
monitor. Make sure the channels match on both units.
2. Signal interference from a microwave oven. Check if a
micro-wave oven is in use or located in the path between
the camera and monitor. If so, turn it off or move it out of the
path.
3. Signal interference from other signal producing devices.
(a) Identify and eliminate the source of the interference.
(b) Relocate the camera and/or monitor closer to each other.
(c) Change the channel setting on both camera and monitor.
4. Camera and monitor are too far apart. Relocate the
camera and/or monitor.
The Camera and
or Monitor Has:
No Power
No picture.
Distorted picture
TROUBLESHOOTING
SPECIFICATIONS
RECEIVER:
SCREEN SIZE ..........2.5" TFT LCD
DOT PITCH..............0.1025 x 0.163 mm
RESOLUTION ..........480 x 234
POWER SUPPLY......5V DC, 1A
OPERATING TEMP. 32°F - 140°F
0°C - 60°C
DIMENSIONS ..........130x80x38mm
BATTERY..................2 Lithium Ion
Rechargeable batteries.
CAMERA:
IMAGE SENSOR ....1/3" Color CMOS
Image Sensor
RESOLUTION ..........380 Horizontal TV Lines
POWER ..................8V DC
ILLUMINATION........1.0 Lux
OPERATING TEMP..14°F - 122°F
-10°C - 50°C
DIMENSIONS ..........92x89x67mm
WEIGHT ..................Approx. 70g