Swann ADW-300 Digital Camera User Manual


 
Camera & Receiver Layout
Camera Parts
1. Camera Lens
2. IR LED
3. Antenna
4. Power Jack
5. Camera Stand
6. 1 CDS
7. Microphone
8. Cam Pair
9. Power adaptor
10. Power LED
11. U holder / U holder
screw
12. T- bolt
13. Sunshield
4
Installation
8
10
9
11
11
12
13
Back side
1
234
6
7
5
8
9
M
Receiver
1. Receiver antenna
2. USB port
3. A/V out
4. DC Power
5. Signal LED
6. Pairing LED
7. Power LED
8. Power supply
9. Mini jack to RCA
cable
Camera Assembly / Adjustment
A. Loosen U holder screws; slide the sunshield to ideal position.
B. U bracket can be installed on camera top side for ceiling mount.
C. Secure U holder with screws when done.
D. Adjust camera for proper view angle. Secure the stand with T-bolt when done.
Step1: Hardware Set Up
9
Pairing Cameras
Pairing key
3
Pairing Camera(s)
This function is available for multi-camera users
It is highly recommended to pair the camera before
hardware installation.
Before pairing the camera, make sure camera is power
ON, camera status indicators shown:
A. Simply pair the camera by selecting the desired channel in the
OSD menu.
B. Only assign one camera to one channel. Channel memory will be
overwritten if the next camera is assigned to the same channel.
C. Pairing new camera to channel 3, settings as shown:
D. Press
(Pair).
E. System will count down within 60 seconds, system message as
shown:
F. Within 10 seconds, press the Pair Key on
the back of camera.
Reset
60
G. Once pairing completed, camera and
receiver status indicators appear as
shown
Reset
A. Select the item “Reset” in the menu.
B. Press
.
C. The original default settings of the system will be restored.