Swann DVR Guardian Security Camera User Manual


  Open as PDF
of 4
 
Step 1: Hardware Installation
Plug in to a spare USB port
on your PC.
1. Doorways
5. Reception
areas
6. Cash
register
7. Mix
dummies
& real
cameras
8. Under
eaves
2. Windows
3. Car Parks
4. Verandahs
You should position your cameras to cover the areas most exposed to risk. See our suggestions below
for some ideas:
Take note that some cameras will require waterproof housing to protect it from the elements if used
outdoors. Direct exposure to the effects of the weather will void the warranty.
Tips for situating your cameras
To help guide you through the process of setting up the Swann USB 2.0 DVR Guardian, we have outlined the
steps and numbered each of the components required in the diagram below.
Follow these steps to install the Swann USB 2.0 DVR Guardian hardware.
Step 1.1. Firstly make sure your computer is turned ON and you are logged into an account with Administrator
privileges to install software.
Step 1.2. Remove the USB DVR Guardian from the pack and locate the USB A plug (1).
Step 1.3. Connect the USB A plug (1) into a spare USB port (2) on your PC.
IMPORTANT: It is highly recommended that this device is plugged into an onboard USB port, and not a
USB hub or add-on port.
* Camera is not included.
36
IMPORTANT: Your Swann USB 2.0 DVR Guardian will be automatically detected by your PC, click “Cancel” or
press the “Esc” key on your keyboard to exit the “Found new hardware wizard” as the drivers are installed
during the software installation process.
2
1
To see a complete range of security solutions, please visit www.swannsecurity.com
 previous