Filter
Top Products
282828
Conexión directa al TV
Conecte el Cable A/V a
los enchufes RCA en la
parte posterior del receptor
1
A
/V
a
e
n la
l rece
p
tor
INPUT 1 INPUT 3 OUTPUT
Conecte el otro extremo del
cable A/V a la ENTRADA en
la parte posterior de su TV
2
Conecte el Adaptador
de Energía del Receptor
3
Nota: Si su televisión o VCR no
tiene la conexión roja de RCA
use la conexión blanca de RCA
9
The Wireless Receiver has a built in Loop Mode that will display cycle between all
active channels every few seconds.
To turn Loop Mode on, move the ’L’ or Loop switch down to the ON position. The
Receiver will automatically switch between active channels every few seconds.
When the Loop switch is ON the LED indicator on the front of the Receiver will
fl ash RED on the current active channel.
The Wireless OutdoorCam operates on 2.4GHz frequency. Some devices such as
wireless routers, microwaves, cordless phones can cause interference and affect
picture quality as they use the same frequency. If you are experiencing interference
or poor image quality try the following steps:
- move or orient the camera in a different location
- adjust or aim the receiver antenna
- limit the number of walls, fl oors between the camera and receiver as this can
dramatically alter picture quality
- dense materials such as concrete or metal will impede the wireless signal; move
the camera and/or receiver away from dense materials
- if possible keep the camera and receiver away from or move confl icting devices
such as wireless routers, microwaves, cordless phones
- make sure all cameras are set to different camera channels
- disconnect all other wireless devices to fi nd out which is causing the problem and
adjust your setup accordingly
- analog wireless cameras are not recommended for use with DVR systems; if you
are looking for a wireless camera solution for recording purposes see the digital
wireless ADW-300 (SW233-ADW) which will not suffer from interference
- some wireless signals may originate from nearby homes or businesses; in this case
a wired camera may be necessary
In this diagram Loop has been turned
on as well as Channels 1 and 4. The
Receiver will cycle from Channel 1 to
Channel 4 every few seconds.
1
23 4L
ON
Setting the Loop Mode
Camera Placement & Interference