Filter
Top Products
D14245.04—DECEMBER 2008 15
PrecisionHD 1080p Camera
User Guide
Remote control
Camera commands
Command Command Packet Comments
Call_LED_On 8x 01 33 01 01 ff Refers to orange LED on top
of camera. Will always be off
at startup.
Call_LED_Off 8x 01 33 01 00 ff
Call_LED_Blink 8x 01 33 01 02 ff
Power_LED_On 8x 01 33 02 01 ff Green power LED. If switched
to off and stored to startup
profile, it will always be off.
Power_LED_Off 8x 01 33 02 00 ff
IR_Output_On 8x 01 06 08 02 ff See IR push message.
IR_Output_Off 8x 01 06 08 03 ff
IR_CameraControl_On 8x 01 06 09 02 ff Lets up/down/left/right/
zoom+/- on the IR remote
control the camera directly.
Those keycodes will be sent to
the controller if IR Output is on.
IR_CameraControl_Off 8x 01 06 09 03 ff
BestView_On 8x 01 50 60 0p 0q ff Turn BestView on or off.
pq=time (in seconds) Will
generate push message(s) as
specified above when the time
runs out.
BestView_Stop 8x 01 50 60 00 00 ff
Command Command Packet Comments
Power_On 8x 01 04 00 02 ff Power control. This command
stores the zoom and focus
value and reset these motors.
Used for Tiger if the camera
was on for a long time.
Power_Off 8x 01 04 00 03 ff
Video_Format 8x 01 35 0p 0q 0r ff Selects video format. p =
reserved. q = video mode. r =
See the chapter about the DIP
switch settings
WB_Auto 8x 01 04 35 00 FF WB: White Balance
WB_Table_Manual 8x 01 04 35 06 ff
WB_Table_Direct 8x 01 04 75 0p 0q 0r 0s ff Used if WBmode = Table
manual pqrs = wb table.
AE_Auto 8x 01 04 39 00 FF AE: Automatic Exposure.
AE_Manual 8x 01 04 39 03 FF
Iris_Direct 8x 01 04 4B 0p 0q 0r 0s FF Used if AE mode = Manual.
pqrs: Iris position, range 0..50
Gain_Direct 8x 01 04 4c 0p 0q 0r 0s FF Used if AE mode = Manual.
pqrs: Gain position, values:12-
21dB.
Backlight_On 8x 01 04 33 02 FF BacklightCompensation mode
Backlight_Off 8x 01 04 33 03 FF
Mirror_On 8x 01 04 61 02 ff Sony calls this CAM_LR_
Reverse. RR (FT/AT mirror
command)
Mirror_Off 8x 01 04 61 03 ff
Flip_On 8x 01 04 66 02 ff Sony calls this CAM_ImgFlip.
Flip_Off 8x 01 04 66 03 ff
Gamma_Auto 8x 01 04 51 02 ff Gamma mode. Default uses
gamma table 4.
Gamma_Manual 8x 01 04 51 03 ff
Gamma_Direct 8x 01 04 52 0p 0q 0r 0s ff pqrs: Gamma table to use in
manual mode. Range 0-7.
MM_Detect_On 8x 01 50 30 01 ff Turn on the Motor Moved
Detection (camera recalibrates
if touched)
MM_Detect_Off 8x 01 50 30 00 ff Turn off the Motor Moved
Detection (camera does not
recalibrate if touched)
What’s in this user guide?
Getting started
Connecting the camera
Making your own cables
Contact information