Filter
Top Products
10
ABOUT THE PIR SENSOR
The sensor that triggers the trail camera is Passive Infra Red, or PIR. Infrared energy is essentially heat energy.
The PIR detector operates by sensing a change in the infrared level in its detection zone. This zone is a cone
in the center 30 degrees of the camera’s eld of view. The camera establishes an average long-term infrared
level. When this level increased suddenly the PIR detector signals the camera to record a picture and/or an
event. Because of this eect, the PIR detector will be more sensitive at night, when the average temperature
is lower.
You can use the red LED indicator on the front of the camera to conrm the detection zone.When PIR is
sensed, this “PIR detected” indicator will light. The camera’s eld of view is a 45 degree cone, centered on the
PIR detection zone.
MOON PHASE STAMP
All new Trail Cam models have a “moon phase” stamp feature. This links the current date (as set by the user in
the setup procedure) to the phase of the moon on that date (this data is stored on an internal memory chip),
and imprints a icon on your photo which represents the moon phase when the photo was taken. The moon
phase icon will appear on your photos in the lower left, next to the Tasco logo. Some hunters will nd this to
be a useful reference, as it can help determine if particular animals are inactive at night when a full or nearly
full moon is present, causing them to be more visible to predators. Or, if some of your night photos seem to
have a darker or lighter background (beyond the range of the ash), you can see if that was related to how
bright the moon was at the time. The icons for the various phases of the moon are shown below:
New Full
Waxing > Waning > New
Additional Notes