Filter
Top Products
9
Setup Guide (cont.)
by “SnAP”, then “SLP” (Sleep). Note: for movie clips, the display will stay on “SnAP” for the 14 sec duration of each
movie.
7. Thread the strap through the slots on the back of the Cam and attach the buckles, then strap it onto a
suitable tree, making sure the strap is tight and the camera is aimed at the area you wish to observe. The
red LED lamp on the front of the camera can help you determine how large an area is covered, as it will ash
when an “event” is detected. Turn on the camera (make sure a new or empty SD card has been inserted) and
leave the area-there is a 60 second delay after power on before the rst photo is taken. Batteries typically last
30 days or more, depending on how often the Cam is activated by events, how often the ash res, ambient
temperature, etc. The red LED lamp will stay on continually to indicate a low battery condition.
8. To view your captured photos, make sure the power is o, and remove the SD card by pushing down lightly
on the top edge of the card-it will pop up for removal. Insert it into an SD card reader (available at most
computer, photo, or electronics dealers) connected via USB to your PC or Mac to view, copy, or delete the
photos (standard JPG les) and movies (AVI les) inside the “DCIM/100MEDIA” folder on the card. Double click
on an individual le to see it, or open the les using the photo software of your choice.