Filter
Top Products
02.38.3 User's Guide LDK 4482 - SuperXpander 1-7
Assembly
It is important that you assemble and disassemble the
units in the right order. The correct order of assembly
is as follows:
1. Attach the large lens adapter to the tripod.
2. Mount the lens onto the large lens adapter.
3. Attach the camera to the large lens adapter.
4. Mount the 7-inch viewfinder onto the large lens
adapter.
To disassemble the units follow this order in reverse.
Tripod
To mount the large lens adapter on a tripod, first
attach the tripod wedge plate to the underside of the
adapter as follows:
a. Lie the large lens adapter on its side.
b. Ensure that the flat side of the tripod wedge plate
is against the underside of the large lens adapter.
c. Secure the tripod wedge plate to the large lens
adapter by screwing four M6 x 16 screws into the
holes provided.
d. Slide the large lens adapter onto the tripod and lock
in place with the tripod locking bar and security pin.
Mounting a Lens
To mount the lens onto the large lens adapter, proceed
as follows:
a. Slide the viewfinder support back towards the rear
of the large lens adapter.
b. Hook the lens onto the support rail ensuring that
the upper lens pin fits into the slot in the support
rail.
c. Swing the lens downwards so that the lower lens
pin fits into the hole in the front of the camera.
d. Turn the lens locking handle clockwise to secure
the lens in place.
If the lens cannot be secured see Information
on the next page
To remove the lens, remove the camera from
the large lens adapter first, then follow this
procedure in reverse.
Viewfinder Mount
Retaining Knob
Bayonent Ring
Locking Lever
Balance Knob
Lens
Locking
Handle
Support
rail slot
Lens
support
rail
L
D
K
1
0
P
70 VA max