Filter
Top Products
8
UL1095#22 Black/ White (Nonpolar)
BNC jack
Camera Input/
Out
p
ut terminal
Cable joint section
BNC plug
Supplied cable
Lock screw
Connects to monitor
Connector
(water-resistant type)
Water-resistant cap
Connects to power supply source
Insulation washers are attached to
the mounting bracket.
Mounting bracket
Camera mounting bolt
Washer-installed M8 x 14mm hex bolt
Insulation spacer
3. Attach the camera to the mounting bracket.
Use the supplied insulation spacers, camera mounting bolts (washer-installed M8 x 14mm hex bolt) to
attach.
Note: Because the induced voltage and noise may be generated at the camera mounts, depending on the
installation environment, be sure to use insulation spacers and washers when attaching. Also, never
remove the insulation washers attached to the mounting bracket.
4. Connect the connector.
Connect the connector of the supplied cable with the water-resistant cap to the camera’s Input/Output
terminal, then tighten the connector’s lock screw.
Notes
• Be sure to fully insert the connector to prevent rainwater from getting in the Camera.
•Wrap the self-adhesive type butyl rubber tape round cable joints to prevent rainwater from entering.