Filter
Top Products
21
The supplied screw driver is exclusively designed to match the dome screws. Do not
discard the screw driver.
Treat silica gel bag with care. Do not tear the silica gel packge.
WARNING:
Keep the silica gel out of the reach of babies, infants, and children.
DO NOT EAT, HARMFUL IF SWALLOWED
1. Align the inner side of the black cover with the notches on both sides of the lens, x
the black cover.
Note:
The black cover cannot be attached if installed in the wrong orientation.
2. You will nd a silica gel bag attached to the camera.
Replace this old silica gel with a new silica gel. The new silica gel is supplied in the
aluminum foil bag. Remove it from the foil bag before installing.
(Please replace the silica gel with a new one if you open the dome cover after
installation.)
3. Attach the dome cover to the camera as shown below. The dome cover cannot be
attatched if installed in the wrong orientation. Align the side cover (or side cutout)
with where the cable comes out from the camera. Push the dome cover to join with
the camera.
Note:
Don't touch the lens and clear cover when installing. Before attaching the
dome cover , remove the protection lm on the lens. Clean the clear cover if
you touch it. After attaching the dome cover, make sure not to cover the light
sensor with dome cover.
4. Secure the three dome screws with the supplied screw driver. Make sure all parts of
the camera are securely installed.
3
1
4
2
Be aware of the cable route!
Completion
Dome cover
Clear cover