Filter
Top Products
rev E Trango Systems, Inc. 1716 PTZ-900 Installation and Operating Instructions
General
Material: cast aluminum
Finish: platinum powdercoat
Size: 4.65″W × 8.8″L × 2.475″D
without antenna
Weight: 2.65 lb
Connectors and Indicators
RF Output: SMA-F connector
FCC Compliance:
The receiver complies with FCC Part
15.299 and FCC Part 15.207(a)
Radio Section
Frequencies: 902.2MHz to 927.8MHz
Cascade Noise Figure: < 6dB
Sensitivity for 10
–6
BER: –95dBm max.
Adj. Channel Rej: > 50dB
Image Rejection: > 60dB
Frequency Plan:
double-conversion 1st IF at 110.6MHz,
2nd at 10.7MHz
LO Stability: 0.0025% PLL-stabilized
(25 ppm) over temperature range
Input Compression Point: > –20dBm
PTZ-900RX Receiver: Mechanical & Environmental
Serial Interface:
DB9 male with ferrite or
four-position terminal block
Power: two-position terminal block
Environmental
Operating Temp. : –20ºC to 70ºC
Storage: –30ºC to 85ºC
Humidity:
100% condensing when installed properly
Shock: sustains 3-axis drop from 5′
Data Output Section
Buffer Size: 48 bytes
Data Output Level: software-selectable
rates between RS232 and RS485/422
(RS485/422 factory default)
Data Rate (User): 1200, 2400, 4800,
9600, or 19200 bps user-configurable
via TrangoLink (9600 factory default)
Format: 8 data bits, no parity, 1 stop bit
(even or odd parity is selectable)
Level limiting: none
Input Impedance: 6kΩ balanced
Max. Output Loading: 3kΩ, 2500pF
Power Section
Input Voltage: 6–13VDC
Current Consumption: 200mA
Parametric Specifications
PTZ-900RX Receiver: Electrical
Trango Systems technical support
online: www.trangosys.com voice: +1 858-653-3900