Filter
Top Products
7
Attach the camera
Attach the camera
bracket to the
mounting screw.
Tighten it a few turns,
then turn the camera to face the direction you want.
Tighten the camera brace up against the bracket to secure it into place.
Unlock the mounting post by turning the wingnut to the left a few turns.
Set the mounting post to the correct angle, then tighten the wingnut until
the post is locked into place.
Adjusting the Sun Shield
If there is too much glare in the camera, you can move the sun shield forward
to provide more shade for the lens. If the top of the picture is cut off, try moving
the sun shield back.
To adjust the sun shield, loosen the bolts on the side of the mounting bracket
(see page 7). Slide the sun shield forward or back, then check the picture in the
receiver display. When the picture is satisfactory, tighten the bolts again.
1.
2.
3.
4.
1
2
4
3
Loosen the
wingnut to
unlock the
mounting
post.
Attach the camera
to the mounting
screw and turn it
to the desired
direction.
Adjust the post to
the correct angle,
then tighten the
wingnut to lock the
post into place.
Tighten the brace against
the camera to
secure it
in place.
1
2
4
3
Loosen the
wingnut to
unlock the
mounting
post.
Attach the camera
to the mounting
screw and turn it
to the desired
direction.
Adjust the post to
the correct angle,
then tighten the
wingnut to lock the
post into place.
Tighten the brace against
the camera to
secure it
in place.