VistaQuest VQ 5010 Digital Camera User Manual


 
- 9 -
• Turning On the Camera:
1.Press the ON/OFF button on as shown in the illustration.
2.Buzzer will beep and indicator lamp will light. The LCD monitor will be
turned on.
3.Press the ON/OFF button again to shutdown the camera.
• Setting the Date, Time and Date Stamp:
Use the following procedure to change the date and time setting.
1.Slide the Function switch to
(capture status).
2.Press the Mode button twice to turn on function menu. Press the
Shutter button.
3.Press or to adjust the date and time. Press or
to advance to the next setting.
5.When finished, press the Shutter button to confirm the setting; press the Menu button to
return to main menu, press the Mode button to exit the menu.
Use the Date Stamp setting to imprint the date on your pictures.
In the Date Time Setting menu. Make sure the camera clock is set to the correct date.
1. Slide the Function switch to (capture status).
2. Press the Menu button and then press or to select [Time Stamp] option.
3. Press or to select [Date Only] or [ Date&Time]
4. Press the Menu button to exit the menu.
• Power Saving:
The camera will automatically power off approximately 30 SEC,1MIN, 3MIN, 5MIN (selectable)
after you do not perform any operation.