Filter
Top Products
5.
RESOLUTION (RES) submenu. Use the
Select
button to
set the still-image resolution to either Mid: 640x480 or
Fine: 1280x1024. Press the Shutter button to confirm
your selection. Note: Fine resolution will result in much
better images, whereas Mid resolution will allow you to
store more images in available memory space.
NOTE
• If you ENABLE the flash, the flash capacitor circuit will
be charged and the red (BUSY) LED will blink for 15 –
30 seconds. The time between images (shot-to-shot
time) will be longer, as well. (Weak batteries may
take longer.)
• Once you save your settings, they will be retained
even if the camera is powered o
ff. The settings will not
be changed until you change then again.
The
Delete Function – Deleting/Erasing Images
1. Press the Mode button twice and “DEL” will appear on
the Status LCD. Press the Shutter button to enter the
delete submenu.
2. Press the Select button to toggle (alternate) between
LAST and ALL. Press the Shutter button to confirm your
choice of LAST or ALL. (“All” will allow you to delete all of
your stored images, whereas “LAST” will allow you to
delete only the last image that you captured.)
3. Finally, a “Y” (for Yes) will appear in the status display.
Press the Shutter button to delete your image(s).
Alternatively, press the Select button change YES (Y) to
NO (N) to cancel the deletion process and exit all menus.