Filter
Top Products
- 7 -
www.vivotek.com
T: 886-2-82455282
F: 886-2-82455532
Installation
In this manual, "User" refers to whoever has access to the Network Camera, and
"Administrator" refers to the person who can configure the Network Camera and grant
user access to the camera.
Hardware installation
Please verify that your product package
contains all the accessories listed in the
foregoing Package Contents. Depending
on the user’s application, an Ethernet cable
may be needed. The Ethernet cable should
meet the specs of UTP Category 5 and not
exceed 100 meters in length.
Upon powering up, the status LED will become lighted first and then the device will go
through booting process. The status LED will be steady orange for getting IP address.
After getting IP Address, the LED will blink orange and red as heartbeat to indicate
alive.
To install in Ethernet
Make sure the Ethernet is firmly connected to a switch hub. After attaching the
Ethernet cable plug in the power adapter. If the LED turns out to blink orange-color, go
to next paragraph “Software installation”.
Connect the power adapter jack to the Network Camera before plugging in to
the power socket. This will reduce the risk of accidental electric shock.