Filter
Top Products
VIVOTEK
User's Manual - 77
Media > Image
Advanced Mode
This section explains how to configure the image settings of the Network Camera. It is
composed of the following four columns: General settings, Picture settings, Exposure, and
Privacy mask.
General settings
Show information in videos and snapshots
Video title: Enter a name that will be displayed on the title bar of the live video as the picture shown
below.
Zoom factor display: If you check this item, the zoom indicator will be displayed on the Home page when
you zoom in/out the live viewing window as the picture shown below. You may zoom in/out the image
by scrolling the mouse wheel inside the live viewing window, and the maximum zoom in will be up to 4
times.
Video Title
Title and Time
Video 17:08:56 2010/11/25
2010/12/09 17:08:56
Video orientation: Flip--vertically reect the display of the live video; Mirror--horizontally reect the display
of the live video. Select both options if the Network Camera is installed upside-down (e.g., on the ceiling)
to correct the image orientation. Please note that if you have preset locations, those locations will be
cleared after ip/mirror setting.
Color: Select to display color or black/white video streams.
Power line frequency: Set the power line frequency consistent with local utility settings to eliminate image
flickering associated with fluorescent lights. Note that after the power line frequency is changed, you
must disconnect and reconnect the power cord of the Network Camera in order for the new setting to
take effect.