Filter
Top Products
- 48 -
www.vivotek.com
Appendix
A. Troubleshooting
Status LED
After powering up, the Network Camera performs a self-diagnostic to detect any
hardware defects. The following table lists the LED patterns in general. In case of any
fatal error, the LED will blink in a pattern other than those below.
Condition LED color
During self-diagnostic after power on Blink in interchanged blue and red
Ethernet signal is lost Steady red till Ethernet is detected
Before network is setup Steady blue till IP address is confirmed
After network is setup Blink blue every second
Network is setup and audio is disabled Blink blue every 4 seconds
Any hardware failure Other patterns
Reset and restore
There is a
button in the back of the Network Camera. It is used to reset
the system or restore the factory default settings.
Sometimes resetting the system sets the system back to
normal state. If the system problems remain after reset,
restore the factory settings and install again.
RESET: Click on the button.
RESTORE:
1. Press on the button continuously.
2. Wait for self-diagnostic to run twice.
3. Free the button as soon as the second self-diagnostic
starts.
Restoring the factory
defaults will erase any previous
settings. Reset or restore the
system after power on.