Filter
Top Products
VIVOTEK - A Leading Provider of Multimedia Communication Solutions
6 - User's Manual
Hardware Reset
There is a reset button on the back cover of the Network Camera� It is used to reboot the
Network Camera or restore the Network Camera to factory default� Sometimes rebooting the
Network Camera could set the Network Camera back to normal state� If the problems remain
after rebooted, restore the Network Camera to factory default and install again�
Reboot: Press and release the reset button� The status LED will blinks in red�
Restore: Press the reset button continuously until the status LED blinks in red and green
simultaneously� Note that all settings will be restored to factory default�
ETHERNET
RESET
IO
1234
P
Reset button
Status LED