Filter
Top Products
- 35 -
www.vivotek.com
T: 886-2-82455282
F: 886-2-82455532
Wireless
“SSID” (Service Set Identifier), it is a name that identifies a wireless network.
Access Points and wireless clients attempting to connect to a specific WLAN
(Wireless Local Area Network) must use the same SSID. The default setting is
default. Note: The maximum length of SSID is 32 single-byte characters and SSID
can’t be any of “, <, > and space character.
“Wireless mode” Clicking on the pull-down menu to select from the following
options:
“Infrastructure” Make the Network Camera connect to the WLAN via an Access
Point. (The default setting)
“Ad-Hoc” Make the Network Camera connect directly to a host equipped with a
wireless adapter in a peer-to-peer environment.
“Channel” While in infrastructure mode, the channel is selected automatically to
match the channel setting for the selected Access Point. In Ad-Hoc mode, the
channel must be manually set to the same channel for each wireless adapter. The
default channel setting depends on the installed region.
“TX rate” This field is for selecting the maximum transmission rate on the network.
The default setting is “auto”, that is the Network Camera will try to connect to the
other wireless device with highest transmitting rate.
“Preamble”, either “Long preamble” or “Short preamble” defines the length of
the CRC block (Cyclic Redundancy Check is a common technique for detecting data
transmission errors) for communication between the Access Point and the roaming
wireless device. Long Preamble is the default setting. Note: High network traffic
areas should use the shorter preamble type.
“Data encryption” Checking the box to enable the data encryption. By default it is
disabled.
“Security” Choosing one of the following data encryptions. By default it is disabled.
z “None” – disables the data encryption.
z “WEP” – uses WEP to encrypt the data.
z “WPA-PSK” – uses WPA pre-shared key to encrypt the data.
“Auth. Mode” Choosing one of the following modes, (Auto is the default setting)
z “Auto” – Will automatically decide the authentication mode of the wireless