Page 6For technical questions, please call 1-800-444-3353.SKU 91764
Lifting
1.
surface able to support at least 1350
lb.
Turn the Lifting Screws (18) clockwise 2.
to evenly raise the Casters (14) off
the ground and limit movement.
With the Access Panel (36) in place, 3.
roll the motorcycle onto the lift. Kick
the center stand of the motorcycle
down to stabilize it on the lift.
Clamp the front wheel of the 4.
motorcycle into the Vise Assembly
to prevent movement of the wheel.
Note: When properly set, front tire of
motorcycle should rest against Stop
Plate (32) and axle of the tire to be
centered over the Front Wheel Vise
Assembly. If not, slide Stop Plate
and/or re-position wheel vise.
Secure the motorcycle to the lift 5.
using tie-down straps (not included).
See motorcycle’s owner manual for
locations of strap attachments.
Pump the Lift Foot Pedal (11) 6.
repeatedly to raise the lift.
Locking Bar (22)
Leveling
Pads (18)
Caster (14)
7. When the platform has been raised
to the working height, pass the
Locking Bar (22) through the holes
in the Front Lifting Arm (38) so the lift
cannot be accidentally lowered.
Gently press release foot pedal to 8.
lower the platform to reset the load
on Locking Bar (22) and not on the lift
jack. Slightly pump up the platform to
free the Locking Bar.
Lowering
Remove all tools, parts, etc. from 1.
under the vehicle.
Remove the Locking Bar (22), then 2.
slowly press the Release Foot Pedal
(10) to ease doen the unit.
NOTE: The speed of lowering is controlled
by the Release Foot Pedal (10).
Operate this pedal slowly in a
controlled and safe manner.
After lowering, open the vise jaws 3.
and remove the motorcycle from the
lift.
Turn the Lifting Screws (18) 4.
counterclockwise to lower the lift onto
the Casters (14).
Store in a safe, dry location out of 5.
reach of children.
Small ATV Application
The Lift can be used to support small 1.
ATV’s under certain conditions. A
small ATV can be rolled onto the Lift if
the wheel width of the ATV falls within
26-3/4” width of the Lift’s platform.
Never attempt to ride an ATV onto the
platform. The Lift should not be used
to support an ATV unless all 4 tires of
the ATV can completely rest on the
platform.
