2 © ITW Ltd 2000
Declaration of Conformity
We, ITW Finishing UK, Ringwood Road Bournemouth Dorset England
declare under our sole responsibility that this product is in conformity with BS
EN 292: parts 1 and 2 :1991 and BS EN 1953:1999, following the provisions
of the Machinery Directive 89/392/EEC. This product also complies with the
requirements of the EPA guidelines, PG6/34. Transfer efficiency certificates
are available on request.
B. Holt, General Manager
Operation Manual
GTi – Gravity Spraygun
Important
Read and follow all instructions and Safety Precautions before using this
equipment
Description
This product is suitable for use with both waterbased and solvent based
coating materials. The design uses EPA compliant atomising technology to
reduce overspray and improve coating efficiency.
Important: These guns are not designed for use with highly corrosive and/
or abrasive materials and if used with such materials it must be expected
that the need for cleaning and/or replacement of parts will be increased. If
there is any doubt regarding the suitability of a specific material contact
your local Distributor or ITW Finishing direct.
E
E
Model Part Number
Example: GTI-G110B-14
Aircap Fluid nozzle size
(14 = 1,4 mm)
Gunbody Finish
M= Multi Colour (colours may vary), B= Blue Anodised
