7 © ITW Ltd 2000
Nozzle (2) and Needle (7) –
Remove parts in the following order:
10, 8, 7, 1 and 2. Replace any worn
or damaged parts and re-assemble
in reverse order. Recommended
tightening torque for nozzle (2) 17-
20 Nm (150-180 lbf in)
Packing – Remove parts 10, 8, 7.
Unscrew cartridge (4). Fit new
cartridge finger tight. Re-assemble
parts 7, 8, and 10 and tighten
cartridge (4) with spanner sufficient
to seal but to allow free movement
of needle. Lubricate with gun oil.
Air valve – Remove parts 6 and 12.
Unscrew valve assembly. Re-
assemble fitting spring to valve head
Spreader valve – Caution: always
ensure that the valve is in the fully
open position by turning screw fully
counter-clockwise before fitting to
body.
Air cap / Nozzle Selection
Refer to coating material
manufacturers recommendations or
ITW Finishing UK Website:
www.itweuropeanfinishing.com
Replacement of Parts
Accessories
Spanner – order SPN-5
Cleaning Brush – order 4900-5-1-K3
Service Kit – order GTi-416 add nozzle size as required (i.e. GTi-416-14)
Pressure gauge Attachment – order GA-515
Gun Mounted Regulator – order DVR-501
Lubricant - order GL-1-K10
E
E
