Note the line breaks shown in the examples are here only for readability. They do not
appear in the real output. Also note that the commands with a non-available example
(N.A.) are not yet implemented.
Motivation
The motivation for this collection of commands.
Introduction
A brief introduction to this collection of commands as a whole.
Commands
For each command in the block, the following is described:
Synopsis
-command args...
GDB command
The corresponding GDB CLI command.
Result
Out-of-band
Notes
Example
21.5 GDB/MI breakpoint table commands
This section documents GDB/MI commands for manipulating breakpoints.
The -break-after Command
Synopsis
-break-after number count
The breakpoint number number is not in effect until it has been hit count times. To
see how this is reflected in the output of the '-break-list' command, see the
description of the '-break-list' command below.
GDB command
The corresponding GDB command is 'ignore'.
312 The GDB/MI Interface
