A-10
INSTALLATION
SYNERGIC 7F & FH
A-10
OPTIONAL FEATURES
INSTALLATION
K648, K649 or K642 Input Cable Assembly - See
Electrical Installation section for instructions.
K299 50-60 Lb. Wire Reel for Customer Mounting -
The K299 is available for use with the Synergic 7F
Wire Feed Models. The reel for 50 or 60 pound coils is
shipped with the needed mounting shaft, hardware,
and insulation. Shaft mounting hole requirements are
shown below:
K683-1 - Dual Procedure Switch
Dual Procedure
Switch mounts to gun with appropriate bracket, provid-
ed, per the installation instructions included with the
kit. 3-pin switch cord plug connects to 3-pin remote
receptacle on the front panel of the Synergic 7F Wire
Feed Unit.
K682-2 Water Connection Kit
- Install to either side
of Wire Feed Unit mounting bracket per instructions
shipped with kit.
K659-1 Gas Guard Regulator - Adjustable flow regula-
tor with removable adjustor key for CO
2
and Argon
blend gases. Mounts onto Wire Feed Unit inlet and
reduces gas waste and arc start “blow” by reducing
surge caused by excess pressure in supply hose.( See
Shielding Gas Connections for instructions).
K1449-1 Dual Procedure Remote Control Provides
remote rotating knob encoder control of Wire Feed
Speed and Volts/Trim, along with a dual procedure
selector switch, which disables comparable front panel
controls when the remote control is connected.
The 4-pin plug of the remote control connects to the
mating receptacle on the bottom of the Synergic 7F
Control box.
The K1450-”L” Extension cable is used to extend the
16 ft (5m) cable attached to the remote control.
Lengths “L” are available to match the Length of the
control to feeder cable being used.
