SPEEDDOME OPTIMA LT PROGRAMMABLE DOME CAMERA 8200-0181-03, REV. C
QUICK REFERENCE GUIDE 6 of 8
AD2083-02B Code Converter
See Supported AD Keyboards on page 5 for
button names used on specific keyboards.
Operate Commands
The controller must be in Operate mode to use
these commands.
Dome Function Keyboard Command
Call Preset 1-16
1-16 Shot
Reset Iris
66 Shot
Flip
67 Shot
Run Pattern # 1
70 Shot
Run Pattern # 2
71 Shot
Run Pattern # 3
72 Shot
Auto Repeat Pattern #1
69 Shot, then 70 Shot
Auto Repeat Pattern #1
69 Shot, then 71 Shot
Auto Repeat Pattern #1
69 Shot, then 72 Shot
In addition, the following commands are not
supported:
• Set Auxiliary 4 OFF (63 Shot)
• Set Auxiliary 4 ON (64 Shot)
Program Commands
The controller must be in Program mode to use
these commands.
Dome Function Keyboard Command
Reset Dome
65 Shot
Program Preset
1-16 Shot
Define Pattern #1
70 Shot
Define Pattern #2
71 Shot
Define Pattern #3
72 Shot
End Pattern Definition
68 Shot
Save New Pattern
69 Shot
Clear Pattern #1
62 Shot
Clear Pattern #2
63 Shot
Clear Pattern #3
64 Shot
Enter V-phase Adjustment
67 Shot, followed by iris
open/close
Exit V-phase Adjustment
67 Shot
MegaPower 48 Matrix Switcher/
Controller System
See Supported AD Keyboards on page 5 for
button names used on specific keyboards.
Dome Function Keyboard Command
Define Pattern # 1
121 - F2
Define Pattern # 2
122 - F2
Define Pattern # 3
123 - F2
End Pattern Definition
120 - F2
Save New Pattern
130 - F2
Go to Pattern # 1
31 - F1
Go to Pattern # 2
32 - F1
Go to Pattern # 3
33 - F1
Run Pattern # 1
21 - F1
Run Pattern # 2
22 - F1
Run Pattern # 3
23 - F1
Auto Repeat Pattern # 1
41 - F1
Auto Repeat Pattern # 2
42 - F1
Auto Repeat Pattern # 3
43 - F1
Clear Pattern # 1
(SpeedDome RS-422)
131 - F2
Clear Pattern # 2
(SpeedDome RS-422)
132 - F2
Clear Pattern # 3
(SpeedDome RS-422)
133 - F2
Flip (Rotate dome 180º)
19 - F1
Reset Iris
20 - F1
Return to Auto Iris / Auto
Focus
69 - F1
Reset Dome
30 - F1
Enter Vertical Phase
Adjust Mode
38 - F2
Exit Vertical Phase Adjust
Mode
39 - F2
In addition, the following commands are not
supported:
• Set Auxiliary 4 OFF (70-F1)
• Set Auxiliary 4 ON (71-F1)
