Anton/Bauer UL-2 Camera Accessories User Manual


 
BULB SELECTION AND OPERATION
Bulbs used by the Ultralight 2 are Type MR16, tungsten-halogen bulbs. Spot or flood bulbs of any light
distribution angle may be used.
The Ultralight 2 offers the greatest versatility with the following low voltage bulbs. They can be
powered from any 12-14.4 volt camera battery with the Ultralight 2 integral PowerTap connector cable.
Triple Purpose Low Voltage Bulb - The ESX, EYR and EYF bulbs provide three beam/output options:
1. Spot (15º) - plain bulb.
2. Medium Spot (approximates 21º) - with Diffuser (UL-DF).
3. Flood (36º) - with Wide Angle adapter (UL-WA) which covers most zoom lenses in the extreme
wide position.
Dual Purpose Low Voltage Bulb - The EXZ bulb provides two beam/output and is a good all around
bulb:
1. Medium Food (24º) - plain bulb.
2. Full Flood (36º) - with Wide Angle Adapter (UL-WA).
Single Purpose Low Voltage Flood Only bulbs. The BAB, EYP, and EYC bulbs provide full flood
(36º) - plain bulb.
Purpose/Type Bulb Code Watts Spot Med Flood Amps
RunTime w/4
AH
Battery
Triple Purpose:
Spot/Med Spot
Flood
ESX
EYR
EYF
25
50
75
200
400
700
85*
170*
300*
30**
60**
120**
1-2/3
3-3/4
6-1/4
120 min
60 min
35 min
Dual Purpose:
Med Flood/Flood
EXZ 60
- - - - -
175 70 4-1/2 45 min
Single Purpose:
Flood Only
BAB
EYP
EYC/FPB
25
50
75/85
- - - - -
- - - - -
- - - - -
- - - - -
- - - - -
- - - - -
35
65
125
1-1/3
3-3/4
6-1/4
120 min
60 min
35 min
NOTE: All above data measured at 14 volts. * with a Diffuser (UL-DF) ** with a Wide Angle
Adapter (UL-WA)
SPECIAL NOTE: Extensive field testing indicates that the ESX bulb, despite its minimal 25 watts,
when used with the UL-WA Wide Angle Adapter, or the plain BAB bulb,
provides the most pleasing lighting condition for most indoor interviews in the
typical 3 ft. to 6 ft. range
SPECIFICATION
LAMPS
Type MR-16
12-14 Volts, 25-85 Watts
Higher wattage bulbs are not recommended due to excessive heat generated by these
bulbs.
WEIGHT Base unit with bulb: 12 oz.
SIZE
Light Head Module: 2¼”W x 2¼”H x 2¾” DP
Base Unit w/Head Module: 2¼”W x 4¼”H x 3¾”DP
SERVICE
If you have any question about this or any Anton/Bauer product, please contact our Customer Service
Department at 1-800-541-1667 (USA Only) or 203- 929-1100.