THE SCREEN LIGHTS UP, BUT I SEE NO PICTURE.
• Camera cable is disconnected. (Plug the camera cable into the
"Camera-In" jack.
• Camera cable might be damaged. (Consult the "Service" section in this
manual.)
SCREWS FOR BALLAST WEIGHTS AND FRONT-VIEWING FIN WON'T GO
THROUGH HOLES IN THE RUBBER CAMERA HOUSING
• With a screwdriver, screw the bolts through the predrilled holes. (The
holes are a little undersized for firmly gripping the bolts to prevent
their loss.)
I LOWER THE CAMERA TO THE BOTTOM BUT CAN'T SEE ANYTHING.
• The camera may be buried in soft bottom! (Raise the camera off the
bottom.)
• The water might be very murky. Select the ON-LIGHT switch position to
activate infrared lights in your camera for enhanced viewing in low-light
conditions.
THERE IS A NICK IN THE CAMERA CABLE.
• See the "Service" section of this manual for instructions on returning
the camera for repair.
THE IMAGE ON MY SCREEN HAS A DARK MARGIN AROUND IT, OR GETS
BLURRY.
• You're seeing on-screen symptoms of a weakening battery. Charge the
battery, or install a charged battery.
ONE-YEAR LIMITED WARRANTY
Nature Vision, Inc., warrants this product to be free from defects in
materials and workmanship for one year from the date of purchase. This
warranty applies to customers who properly fill out, clip, and return the
warranty card included on the back cover of this manual. Failure to
complete and return the warranty card voids this warranty. Nature Vision,
Inc., will, at its sole discretion and without charging the customer,
repair or replace any components that fail in normal use. Failures due to
abuse, misuse, or unauthorized alteration or repair, are not covered. The
warranty is valid only for the original owner.
EXTENDED WARRANTY
A two-year extended warranty is available through Nature Vision, Inc.You
may purchase this warranty within 30 days of purchasing the unit. Visit www.
aquavu.com for more information.
Nature Vision, Inc. © Copyright 2000 Pg 9