Filter
Top Products
4 Use without Wind Deflector Screws (#8-32 UNC x 7.5)
4 Use with Wind Deflector Screws (#8-32 UNC x 9.0)
AOM-58 Monochrome Monitor
Qty.
1 5” Monitor
1 Snap-On Sun Visor
1 Monitor Bracket
1 Power Harness with locking connector
1 Range marker
4 Thumb screws (M5 x 15) with plain washer and spring washers
4 Attachment screws with washers (M5 x 12)
OCA-80 Cable
Qty.
1 20 meter cable with waterproof connector. Oil, gas, and grease
resistant. UV stable
Documents
1 Operators manual
BEFORE INSTALLATION:
1. To prevent electrical shock, DO NOT OPEN THE MONITOR CASE. There
are potentially lethal voltages, inside the monitor. There are no user
serviceable parts inside. If evidence of tampering is detected, the
Warranty will be considered void.
2. Keep the monitor away from leaking water, rain, moisture, etc. It is not
waterproofed. Any moisture inside the monitor could cause extensive
damage.
3. Use the thumbscrews to mount the monitor to the bracket.
**CAUTION**
1. Do not open the camera case. This will break the camera’s waterproof
seal. If evidence of tampering is detected, the warranty will be
considered void.
2. Do not mount the camera near the lower area of the vehicle (e.g.
bumper). This reduces the view of camera and may cause physical
damage to the camera.
INSTALLATION INSTRUCTIONS
AOC-75 CAMERA
1. Attach camera bracket (See Figure 1) to upper portion of vehicle.
Attachment point must be sturdy enough to support camera and
bracket.
2