Filter
Top Products
22 Installing SG203 and SG208 Security Gateway March 2004
Avaya SG203/SG208 Security Gateway Hardware Installation Guide
Note: If DHCP related functionality (DHCP server on the private
interface and DHCP client on the public network) disrupts your
network, change the default settings via the console port, prior to
plugging in the ethernet cables.
2. Connect one end of the Cat5e straight-through cable to the private
port (Ethernet0) on the security gateway. Connect the other end to the
LAN hub or switch.
Note: A crossover cable is required if the SG203 security gateway is
connected directly to a workstation.
3. Connect the power cable to the security gateway and then plug it in to
an AC outlet.
4. Power on the security gateway and proceed to Chapter 3, Setting up
the security gateway for configuration.
The following are the default values for the security gateway.
• DHCP Client public interface is enabled
• DHCP Server private interface is enabled
• Private Interface IP address is 192.168.1.1
• Administrative user name is root
• Password is password