Filter
Top Products
9
AXIS 223M - Accessing the Camera
Setting the root password
1. When accessing the camera for the first
time, the Configure Root Password
dialog will be displayed on the screen.
2. Enter a password and then re-enter it, to
confirm the spelling. Click OK.
3. The Enter Network Password dialog will appear. Enter the User name: root
Note: The default administrator user name root is permanent and cannot be
deleted or altered.
4. Enter the password as set in step 2 above, and click OK. If the password is lost,
the camera must be reset to the factory default settings. See Resetting to the
factory default settings, on page 50.
5. If required, click Yes to install the AXIS Media Control (AMC). You will need
administrator rights on the computer to do this.
Accessing the camera from the Internet
Once installed, the camera is accessible on your local network (LAN). To access the camera
from the Internet you must configure your router/firewall to allow incoming data traffic.
For security reasons this is usually done on a specific port. Please refer to the
documentation for your router/firewall for further instructions.
For more information, please visit the AXIS Internet Dynamic DNS Service at
www.axiscam.net or, for Technical notes on this and other topics, visit the Axis Support
Web at www.axis.com/techsup
Setting the focus
To focus the AXIS 223M, follow the instructions below.
1. From the Basic Configuration page in the setup tools, open the Focus
Adjustment page.
2. Set the DC-Iris to Disabled
and click Save.
3. Unscrew the zoom puller on
the lens by turning it
anti-clockwise. Adjust the
zoom setting as required.
Re-tighten the zoom puller.
4. Unscrew the focus puller on
the lens. Adjust the focus as
required. Re-tighten the focus puller.
5. From the Focus adjustment page, set the DC-Iris to Enabled and click Save.
Zoom puller
(Tele/wide)
Focus puller