Filter
Top Products
36
AXIS P1311 - Unit connectors
Unit connectors
Network connector - RJ-45 Ethernet connector. Supports Power over Ethernet. Using shielded cables is recommended.
Power connector - 2-pin terminal block used for power input.
Audio in - 3.5 mm input for a mono microphone, or a line-in mono s
ignal (left channel is used from a stereo signal).
Audio out - Audio output (line level) that can be connected to a public
address (PA) system or an active speaker with a
built-in amplifier. A pair of headphones can also be attached. A stereo connector must be used for the audio out.
SDHC memory card slot
- A standard or high capacity SD memory card can be used for local recording with removable
storage.
To insert an SD card, lift the SD card cover on the rear of the AXIS P1311, and carefully insert the SD card into its slot.
To remove an SD card lift the cover and gently push
the card in and release it. The SD card will come out of the slot and can
be removed.
Note:
Bef
ore removing the SD card, it should be unmounted to prevent corruption of recordings. To unmount the SD card, go
to Setup > System Options > Storage > SD Card > Disk management and click Unmount.
Function Pin number Description
GND 1 Ground
DC Power 2 Power input 8-20V DC, max 2.8 W.
1
2
SD memory card slot