Filter
Top Products
4 en | Safety Instructions 1200 Series IP Video Storage System
DOC | V1 | 2010.08 Installation Manual Bosch Sicherheitssysteme GmbH
1 Safety Instructions
1.1 Overview
This chapter provides a quick setup checklist to get your chassis up and running. Following
the steps in the order given should enable you to have your chassis setup and operational
within a minimal amount of time. This quick setup assumes that you are an experienced
technician, famailiar with common concepts and terminology.
1.2 Warnings and Precautions
You should inspect the box the chassis was shipped in and note if it was damaged in any way.
If the chassis itself shows damage, file a damage claim with carrier who delivered your
system.
Avoid areas where heat, electrical noise and eletromagnetic fields are generated. Position the
chassis near at least one grounded power outlet.
1.3 Preparing for Setup
The 1200 Series chassis contains many features that are unique to the 1200 Series chassis
model. Read this manual in its entirety before beginning the installation procedure.
1.4 Electrical Safety Precautions
Basic electrical safety precautions should be followed to protect yourself from harm and the
1200 Series from damage:
– Be aware of the locations of the power on/off switch on the chassis as well as the room’s
emergency power-off switch, disconnection switch or electrical outlet. If an electrical
accident occurs, you can then quickly remove power from the system.
– Do not work alone when working with high voltage components.
– Power should always be disconnected from the system when removing or installing main
system components, such as the serverboard, memory modules and optical device
drives. When disconnecting the power, you should first power down the system with the
operating system and then unplug the power cords from all the power supply modules in
the system.
– When working around exposed electrical circuits, another person who is familiar with the
power-off controls should be nearby to switch off the power, if necessary.
– Use only one hand when working with powered-on electrical equipment. This is to avoid
making a complete circuit, which will cause electrical shock. Use extreme caution when
using metal tools, which can easily damage any electrical components or circuit boards
they come into contact with.
– Do not use mats designed to decrease electrostatic discharge as protection from
electrical shock. Instead, use rubber mats that have been specifically designed as
electrical insulators.
– The power supply power cord must include a grounding plug and must be plugged into a
grounded electrical outlet.
– Serverboard battery: CAUTION - There is a danger of explosion if the onboard battery is
installed upside down, which will reverse its polarities This battery must be replaced only
with the same or an equivalent type recommended by the manufacturer. Dispose of used
batteries according to the manufacturer’s instructions.