Filter
Top Products
LTC 9384 Series | Instruction Manual | Installation
EN
|
13
Bosch Security Systems | September 1, 2004
FIGURE 12 Breather Hole
Proper installation of the pull seal is as follows:
1. Remove the cradle assembly from the housing.
2. Obtain a rubber pull seal (Part Number
315 2569 001) from the hardware kit (see
FIGURE13). An extra pull seal is also provided.
FIGURE 13 Pull Seal
3. Insert the long end of the pull seal into the
breather hole starting from the front of the
endcap (see FIGURE 14).
FIGURE 14 Inserting the Pull Seal
4. Grip the pull seal's long end from the back of
the front endcap. Steadily pull the long end until
the head of the pull seal is flat against the front
of the endcap (see FIGURE 15).
NOTE: The pull seal's long end will stretch
when pulled through the breather hole.
FIGURE 15 Installing the Pull Seal
5.9.2 Cradle Assembly
1. Position the housing vertically and replace
the cradle assembly by applying pressure
onto the rear cap until the end of the cradle
is approximately flush with the back of the
housing (see FIGURE 16).
FIGURE 16 Inserting the Cradle Assembly
CAUTION: If a pull seal is installed in the
breather hole, be careful not to pinch the head of
the pull seal. Damage to the pull seal may allow
water to enter the housing, causing damage to
the camera and lens.
2. Tighten the retention screw, making sure it is
seated into the rear cap groove. If the housing
needs to be tamper-resistant, the LTC 9380/02
(purchased separately) should be installed at this
time.
3. Attach the housing to the appropriate mount
or pan/tilt per the instructions provided.
According to the orientation of the housing, the
cradle assembly may need to be rotated. To
rotate the cradle assembly (while mounted),
grasp the rear handle and rotate it to the desired
position. View the monitor while rotating.
Long End
Head
Front of
Endcap
Pull Seal
Breather Hole
Cradle
Front Face
Breather Hole
Front Endcap
Rear Face of Head Should
Be Flush with Front Face
of Front Endcap
Grip and Pull