Filter
Top Products
IP Camera 200 Series Advanced Mode | en 53
Bosch Security Systems Installation and Operation Manual AR18-10-B012 | v1.5 | 2011.01
Note:
If a device had primary and secondary recording running on the
SD card and is then added to a VRM system, the blocks used for
primary recording will not be re-used, reducing the available
recording space for ANR recording. This can be solved by re-
formatting the SD card.
Throughput limit for simultaneous recording and local replay at
100% playback speed is:
– maximum total recording bit rate of 7 Mbps for external
iSCSI recording.
– maximum total recording bit rate of 10 Mbps for SD card
recording, depending on SD card performance.
Activating and Configuring Storage Media
The storage overview displays the available storage media.
Select individual media or iSCSI drives and transfer these to the
Managed storage media list. Activate the storage media in this
list and configure them for storage.
Note:
Each storage medium can only be associated with one user. If a
storage medium is already being used by another user,
decouple the user and connect the drive to the camera. Before
decoupling, make absolutely sure that the previous user no
longer needs the storage medium.
1. In the Recording media section, click the iSCSI Media or
Local Media tab to display the applicable storage media in
the overview.
2. In the Storage overview section, double-click the required
storage medium, a SD card, an iSCSI LUN or one of the
other available drives. The medium is then added to the
Managed storage media list. Newly added media is
indicated in the Status column by the status Not active.
3. Click Set to activate all media in the Managed storage
media list. These are indicated in the Status column by the
status Online.