Filter
Top Products
6 en | Installing the Recessed Camera Mount Flush Mount Ceiling Kit
F.01U.126.944 | 1.0 | 2009.04 Mounting Guide Bosch Security Systems, Inc.
2.2 Mounting the FlexiDome IP Camera
Use the following image as a reference for the following
procedure:
Figure 2.2 FlexiDome IP components
1. Determine a secure location for the flush mount ceiling kit.
Refer to Table 2.1, Page 4, for weight information.
2. If the ceiling tile is too thin or if it requires extra support,
refer to Section 2.1 Installing the VDA-NWDSKT Bracket,
Page 5.
3. Remove the Recessed Bracket and the template from the
VDA-NWDFMT packaging.
4. Mark the ceiling along the perimeter of the template; then
cut the ceiling along the template mark.
1 Mounting plate
2 Camera module/base
3 Inner liner
4 Trim ring and dome
!
WARNING! The ceiling tile or the drywall must be between
6–23 mm (.24–.91 in.) thick.