Filter
Top Products
VIP X1600 B Safety Information | en 7
Bosch Security Systems Installation and Operating Manual F.01U.081.492 | V4.0 | 2008.04
2Safety Information
2.1 Electric Shock Hazard
– Never attempt to connect the unit to any power network other than the type for which it
is intended.
– Use only power supply units approved by Bosch Security Systems.
– Never open the housing of the power supply unit.
– Always install a module in the appropriate VIP X1600 B base housing only.
– If a fault occurs, disconnect the VIP X1600 B from the power supply and from all other
units.
– Install the power supply and the unit only in a dry, weather-protected location.
– If safe operation of the unit cannot be ensured, remove it from service and secure it to
prevent unauthorized operation. In such cases, have the unit checked by Bosch Security
Systems.
Safe operation is no longer possible in the following cases:
– if there is visible damage to the unit or power cables,
– if the unit no longer operates correctly,
– if the unit has been exposed to rain or moisture,
– if foreign bodies have penetrated the unit,
– after long storage under adverse conditions, or
– after exposure to extreme stress in transit.
2.2 Installation and Operation
– The relevant electrical engineering regulations and guidelines must be complied with at
all times during installation.
– Relevant knowledge of network technology is required to install the unit.
– Before installing or operating the VIP X1600 B, make sure you have read and understood
the documentation for the modules in use and for any other equipment connected to it,
such as cameras or monitors. The documentation contains important safety instructions
and information about permitted uses.
– Perform only the installation and operation steps described in this manual. Any other
actions may lead to personal injury, damage to property or damage to the equipment.
2.3 Maintenance and Repair
– Never open the housing of a VIP X1600 B base. The unit does not contain any user-
serviceable parts. Remove only the supplied cover when installing a module.
– Do not change any components in a VIP X1600 B base or a module. The units do not
contain any user-serviceable parts.
– Never open the housing of the power supply unit. The power supply unit does not contain
any user-serviceable parts.
– Ensure that all maintenance or repair work is carried out only by qualified personnel
(electrical engineers or network technology specialists).