Filter
Top Products
VIP X1600 XF Maintenance and Upgrades | en 19
Bosch Security Systems Installation and Operating Manual F.01U.082.088 | V3.5 | 2008.05
5 Maintenance and Upgrades
5.1 Testing the Network Connection
You can use the ping command to check the connection between two IP addresses. This
allows you to test whether a unit in the network is active.
1. Open the DOS command prompt.
2. Type ping followed by the IP address of the unit.
If the unit is found, the response appears as Reply from ... followed by the number of bytes
sent and the transmission time in milliseconds. If not, the unit cannot be accessed over the
network. This might be because:
– The VIP X1600 XF is not correctly connected to the network. Check the cable
connections in this case.
– The module is not correctly integrated into the network. Check the IP address, subnet
mask and gateway address.
5.2 Unit Reset
You can use the Factory Reset button to individually restore each module to its original
settings. It is not possible to reset the VIP X1600 XF base.
5.3 Repairs
Ensure that all maintenance or repair work is carried out only by qualified personnel
(electrical engineers or network technology specialists). In case of doubt, contact your
dealer's technical service center.
5.4 Transfer and Disposal
The VIP X1600 XF, the VIP X1600 XF base or a module should only be passed on together with
this Installation and Operating Manual.
Your Bosch product is designed and manufactured with high-quality materials and
components which can be recycled and reused.
This symbol means that electrical and electronic equipment, at their end-of-life, should be
disposed of separately from your household waste.
In the European Union, there are separate collection systems for used electrical and electronic
products. Please dispose of this equipment at your local community waste collection/
recycling center.
!
CAUTION!
Do not change any components in the modules or the VIP X1600 XF base. The unit does not
contain any user-serviceable parts.