Filter
Top Products
22 en | Camera Adjustments Integrated IR Dome Camera
TBD | 2.0 | 2010.12 Installation Manual Bosch Security Systems, Inc.
Figure 4.5 Maximum tilt angle of 70 degrees
Follow these steps to adjust pan, tilt, and focus/zoom settings:
1. Loosen the 2 cross head screws that secure the pan
position of the camera.
2. Loosen the cross head screw that secures the tilt position
of the camera.
3. Adjust the pan (360˚), tilt (70˚), and rotate as necessary.
4. To adjust the focus and zoom settings, loosen the focus
and zoom adjustment screws located on the camera
module, and adjust until desired image is obtained.
5. Fasten the focus and zoom adjustment screws to fixate
these settings.
6. Fasten the three cross head screws to fixate the camera
position.
NOTICE!
Do not pan or rotate beyond 360˚and do not tilt beyond 70˚ as
shown in Figure 4.3, Figure 4.4, and Figure 4.5 above.
Do not apply excessive force when adjusting the camera
positioning.