Filter
Top Products
20 en | Installation VideoJet X40 SN
DOC | V4.0 | 2009.06 Installation and Operating Manual Bosch Security Systems
4.3 Connections
Cameras
You can connect four video sources to the VideoJet X40 SN. Any cameras and other video
sources that produce a standard PAL or NTSC signal are suitable.
1. Connect the cameras or other video sources to the BNC sockets Video In 1 to Video In 4
using a video cable (75 Ohm, BNC plug).
2. If the video signal is not looped through, termination is performed by a software setting if
necessary (see Section 5.17 Advanced Mode: Video Input, page 46).
Audio Connections
The VideoJet X40 SN has two audio ports for audio line signals.
The audio signals are transmitted two-way and in sync with the video signals. As a result, you
can connect a speaker or door intercom system at the destination point, for example. The
following specifications should be complied with in all cases.
The stereo plugs must be connected as follows:
1. Connect two audio sources with line level to the Audio In socket of the VideoJet X40 SN
with a 3.5 mm stereo plug.
2. Connect a unit with line-in connection to the Audio Out socket of the VideoJet X40 SN
with a 3.5 mm stereo plug.
Network
You can connect the VideoJet X40 SN to a 10/100 Base-T network using a standard UTP
category 5 cable with RJ45 plugs.
X Connect the VideoJet X40 SN to the network via the ETH socket.
CF Slot
You can insert a type I or II CompactFlash card into the Compact Flash slot to enable
recordings to be saved locally. CF cards are the ideal solution for shorter storage times and
temporary recordings, for example alarm recordings or local buffering in the event of network
interruptions.
Playing back recordings is also possible using a different VideoJet X40, a VideoJet X10 or a
VideoJet X20.
2 × Line In: Impedance 9 kOhm typ., 5.5 V
p-p
max. input voltage
1 × Line Out: Impedance 10 kOhm typ., 3.0 V
p-p
max. output voltage,
impedance 16 Ohm min., 1.7 V
p-p
max. output voltage
Contact Line In function Line Out function
Tip Channel 1 Channel 1
Middle ring Channel 2 –
Lower ring Ground Ground
i
NOTICE!
You can obtain a list of compatible CF cards from your supplier or directly from Bosch
Security Systems. This list is constantly being updated and extended.