Filter
Top Products
23
Starting [Scan First] with the START
Button
Under default settings, [Scan First] is assigned to the START button
on the operation panel.
When “Ready” appears on the display panel, press the START button
after placing your document in the scanner. CaptureOnTouch starts
up and [Scan First] begins. When document scanning is finished, the
output method selection screen appears. Perform the procedure from
step 5 onward to output the scanned images.
Hint
If “Ready” does not appear on the display panel (for example, the job
title of a previous scan job will remain on the display after you perform
the job), you can make it appear by pressing the STOP button.
CaptureOnTouch Scanner Settings
CaptureOnTouch provides the following settings for configuring
scan conditions.
[Color mode]
Select the mode for scanning documents (auto color detection,
color, grayscale, or black and white (binary)).
[Page Size]
Specify the page size of documents.
[Orientation]
Specify the orientation in which documents are fed into the scanner
(portrait or landscape).
[Dots per inch]
Specify the scanning resolution.
[Scanning Side]
Specify whether to scan only one side of a document or both sides.
If you select [Skip blank page] and a blank page is detected within
the document while scanning, the blank page is skipped.
[Deskew]
When a document is scanned at an angle, the slant is detected and
straightened in the scanned image.
[Text orientation recognition]
The orientation of text in scanned images is detected, and the
images are rotated to match the orientation of the text.
[Use advanced settings dialog box]
Open the ISIS/TWAIN driver settings screen, and configure
advanced scan conditions. For details on the settings in the driver
settings screen, refer to the Help. (Click the [Help] button in the
settings screen to open the Help.)
IMPORTANT
Certain settings are found in both the ISIS/TWAIN driver settings
screen and the CaptureOnTouch scanner settings. If you clear the
[Use advanced settings dialog box] check box after configuring
ISIS/TWAIN driver settings, the CaptureOnTouch scanner settings
are enabled.
START Button