Filter
Top Products
61
Advanced Functions
Recording
E
Audio Recording
Changing the Audio Mode
You can record sound in two audio modes—16-bit and 12-bit. The 12-bit mode records
sound on two channels (stereo 1), leaving 2 channels free (stereo 2) for adding new
sound later. Select the 16-bit mode for higher sound quality.
Open the menu and select [AUDIO SETUP]. Select [AUDIO MODE], set it
to [16bit] and close the menu.
“16bit” appears for approximately 4 seconds.
Using Headphones during Recording
The headphones terminal also serves as AV terminal. Headphones can only be used
when “ ” is displayed on the screen. If not, change the setting following the procedure
below.
Open the menu and select [VCR SETUP]. Select [AV/PHONES ], set it to
[PHONES ] and close the menu.
Adjusting the Headphone Volume
Open the menu and select [AUDIO SETUP]. Select [ VOLUME], adjust
the volume with the SET dial and close the menu.
You can turn off the volume completely by turning the SET dial down until [OFF] appears.
Turn the SET dial up to increase the volume again.
CAMERA
PLAY (VCR)
CARD CAMERA CARD PLAY
MENU
(38)
AUDIO SETUP AUDIO MODE
•••
12bit
CAMERA PLAY (VCR) CARD CAMERA CARD PLAY
MENU
(38)
VCR SETUP AV/PHONES
••
AV
CAMERA
PLAY (VCR)
CARD CAMERA
CARD PLAY
MENU
(38)
AUDIO SETUP VOLUME
•••••