Filter
Top Products
25
•
A blinking access lamp indicates that data is being read, written, or
erased on the CF card or that data is being transferred. To prevent
damage to the image data, CF card, or camera, never do the
following while the access lamp is blinking:
• Shake or hit the camera.
• Open the CF card slot cover.
• Remove the battery.
This is to prevent damage to the image data, CF card, or camera.
•
The menu cannot be used during image processing after image capture
and while the image is being recorded onto the CF card (access lamp
blinks).
•
If “ ”(Error CF) is displayed, see page 98.
•
If you use a low-capacity CF card, it might not be able to record large
images.
•
A microdrive is vulnerable to vibration and physical shock. If you use a
microdrive, be careful not to subject the camera to vibration or physical
shock especially while recording or displaying images.
Removing the CF Card
Installing and Removing the CF Card
Open the cover.
•
Set the Power switch to <2>.
•
Check that the “ ” message is not
shown on the LCD panel.
•
Make sure the access lamp is off, and
open the cover.
1
Remove the CF card.
•
Press the Eject button.
s
The CF card is ejected.
•
Close the cover.
2
Access lamp