Canon MV500 Camcorder User Manual


 
96
E
Additional
Information
Preparing the Camcorder
Set the camcorder to CAMERA mode.
Extend the viewfinder straight out, then
adjust the viewfinder focusing lever to
suit your eyesight.
Rotate the viewfinder to an angle that
allows you to view comfortably. Store
the camcorder with the viewfinder flush
with the body of the camcorder.
To view with the viewfinder, make sure
the LCD panel is either turned so that the
subject can monitor viewing, or totally
closed with the screen facing inwards.
Adjust the viewfinder
• Be careful not to leave the viewfinder exposed to bright sunlight, or it will
melt. (The light is concentrated by the viewfinder lens.) Adjust the angle of the
viewfinder to prevent sunlight from entering.
Prepare the lens cap
Attach the cord to the lens cap, and
pass the grip belt through the loop on
the cord.
Hook the lens cap on to the grip belt
while you are recording, and place it
over the lens when you have finished.
Fasten the grip belt
Release the Velcro fastening and hold
the camcorder with your right hand
while you adjust the belt with your left.
Your index finger should reach the
zoom control and photo button, and
your thumb should reach the start/stop
button comfortably.
#5_ MV500/MV500i__E(96-121) 2/6/02 14:19 Page 96