Filter
Top Products
AXIS 2110 User’s Manual Physical Description
7
Physical Description
Read the following information to familiarize yourself with the AXIS 2110, making
particular note of where the connectors and indicators are located. This information
provides a useful reference during the installation of the product.
Front Panel
Important!
Although the AXIS 2110 is intended for outdoor and indoor use, it is important to note that the charged coupled
device (CCD) in the camera can become permanently damaged if it is exposed to too much direct sunlight, or halo-
gen light. Therefore, it is important that the Adjustment Ring is not set fully open when installing the camera in
bright light conditions. The Axis warranty does not cover CCD damage caused by prolonged exposure to strong light.
Control Button
Located to the left of
the lens assembly; this
button is recessed
within the product cas-
ing. Using a suitably
pointed object, press
this button to restore
the factory default set-
tings as described in
Reinstating the Factory
Default Settings, on
page 28; or enable the
Focus Assistant, as
described in Lenses and
Focusing, on page 39.
Lens Assembly
Manual iris
Tele/wide zoom
lens with rotational
focus control.
The supplied lens is
removable and can
be replaced with
any standard C/CS
lens.
Serial Number
Located on the underside label of the
AXIS 2110, the serial number is identical
to the Ethernet address of the unit.
Status Indicator
Used in conjunction with the Focus Assistant, this multi-colored indicator can be con-
figured for use as a local focusing aid (for further details please refer to Lenses and
Focusing, on page 39). Under normal conditions however, this indicator shows the oper-
ational status of the camera, as described below:
• green - the indicator flashes briefly and momentarily displays orange during the
start-up and self-test routines. The indicator then displays green to indicate a
healthy unit status.
• red - the indicator will display red only if a problem with the AXIS 2110 has
occurred. Refer to Appendix B - Troubleshooting.
Note: The Status indicator also displays orange when re-setting to the factory default
settings, as described in Reinstating the Factory Default Settings, on page 28.