Filter
Top Products
cathode, it is not allowed to leave the device
motionless in a turned on condition in the excessively
bright environment (in the morning, in the evening, in
a daytime) for more than 30 minutes.
Utilization of the Device in Dark Time
1. Open the cover of the objective lens.
2. Turn on the device – position ON of the switch (8). Green
light should appear on the screen (passive mode).
3. Turning the eyepiece (3) reach the sharpest image of the
mark.
4. Choose the object of observation and focus the objective
of the device with the handle (10) until you see a
distinct and sharp image of the observed object.
5. When illumination of the observed object is required,
turn on (8) the IR illuminator (active mode). You can
select one of the three positions changing the
illuminator’s power (10, 35 or 75 mW).
6. Having finished the work, turn the ON / OFF switch (8) to
the OFF position.
7. Close the cover of the objective after you have finished
the work of the device.
RECOMMENDATION.
When the device is stored for a long time it is
recommended not to leave batteries in the compartment
of the device in order to avoid leakage of the
batteries.
DO NOT FORGET TO TURN OFF THE DEVICE AFTER USE!
Adaptation to a Hunter’s Rifle
Your night vision scope NVD-NORS210/220 can be used as a
hunter’s night vision scope.
RECOMMENDATION.
We recommend you verify the order of usage of the
hunter’s scope on your rifle with the local competent
authorities.
Your night vision scope NVD-NORS210/220 can be used with
different types of mountings, providing reliable fixation
of the device on the particular rifles. Manufacturers of
civil rifles do not possess uniform standards for a
mounting place of optical devices, and as a result, a
universal fastening device is not available. Dedal-210 is
supplied with a fastening mount without hard fastening to
the body, in most cases allowing the performance of special
adaptation of the device for a particular model of rifles.
For this purpose you should address a specialized rifle
workshop or implement the fastening yourself, if you
possess enough knowledge of the system. The NVD-
NORS210/220 are shipped with a standard Weaver mount rail
system. If this works with your system, move to the
Variant II Section.
Adaptation rules.
Variant I – Adapter rail with Standard Prism type.
Fastening of the device is made with the help of the
following parts:
1- body of the device
2- front feet with of the
Standard prism
3- rear feet with the
Standard prism
4- adaptor rail with
Standard prism
5- fastening screws
6- transverse screws.