Filter
Top Products
MULTI Stroboscopic Flash
With stroboscopic flash, a rapid series of flashes is fired. It can be used to
capture multiple images of a moving subject
in
a single photograph for later
study.
You
can set the firing frequency (number of flashes per sec. expressed as
Hz), the number of
flas"hes,
and the flash output.
Zoom
SDmm
1/128
- -
1Hz
Press the
<MODE>
button so that
<MULTI>
is
displayed.
0.5 0.7 1 1.5 2 3 4 6 9
13
18 m
Select the item to be set.
0if
Press the
<@>
button to select the item
(blinks).
Set the desired setting.
ftfj Turn the
<@>
dial to set the setting, then
press the
<@>
button.
1>
The next item to
be
set will blink.
\bY!
After you set the flash output and press the
<@>
button, the entire display will turn on.
Calculating the Shutter Speed
During stroboscopic flash, the shutter should remain open until the firing
stops. Use the formula below to calculate the shutter speed and set it with
the camera.
Number of flashes
~
Firing frequency (Hz) = Shutter speed
For example,
if
the number of flashes
is
10 and the firing frequency
is
5
Hz,
the shutter speed should
be
at least 2 sec.
24